Virtual Copilot
Your Imaginary First Officer Airplane

The AudioContext was not allowed to start. (Click on the page to start it)

Instructions

Additional information

Alternative voice commands:

At the time of writing, only Chromium based browsers (Chrome, Edge) support speech recognition, and Edge's speech recognition works best.
Privacy warning: The built-in speech recognition sends your voice to a cloud service run by your browser's maker.
Privacy respected: This page does not contain external scripts nor does it try to track you.

# apt-get install speech-dispatcher espeak
# spd-conf -C
$ spd-say "Hello, world!"
$ chromium --enable-speech-dispatcher

Settings

Checklist

Included Items

Speech Synthesizer

  • Read checklist items

Not all voices support pitch and speed settings

Speech Recognizer

Page Style

Joysticks

If your controller isn't listed, you may have to press a button, or unplug the controller and plug it in again.

Debug Markers
? needs clarification
! not implemented in sim
! has screenshot
ALTRNT WRDNG when spoken

Checklists

Boeing 737-800

  1. Preflight

    1. Parking brake SET
    2. Battery (OHP) ON & COVERED
    3. Standby PWR AUTO & COVERED
    4. DC-voltmeter-SLCTR (L) BAT
    5. DC-voltmeter-SLCTR (R) STBY PWR
    6. Master caution DISENGAGE
    7. HYD pumps ALL OFF
    8. Fuel pumps ALL OFF
    9. Interior lights (Pedestal) AS REQUIRED
    10. Interior lights (Main panel) AS REQUIRED
    11. Interior lights (Overhead panel) AS REQUIRED
    12. Cabin/utility power ON
    13. IFE PASS seat power ON
    14. Ground power (GPU, ASI, ACU) CONNECT & ON
    15. Pitot covers REMOVE
    16. AC-voltmeter-SLCTR (R) GRND PWR
    17. Emergency lights ON
    18. Position lights: STEADY
    19. Lights: Wheel well, wing, logo ON
    20. Seat belts AUTO
    21. Enter into FMC FUEL/PAYLOAD
    22. Recirc. fans (L & R) AUTO
    23. Packs (L & R) AUTO
    24. Isolation valve AUTO
    25. Speed brake OFF
    26. IRS SEL TEST & HDG/STS
    27. IRS Selectors (L & R) ALIGN
    28. Enter into FMC and complete INIT REF
    29. IRS selectors (L & R) NAV
    30. Enter into FMC and complete ROUTE

      See FMC tutorial: Enter the Flight Plan, Waypoints, Remove Discontinuities.

    31. Enter into FMC and complete PERF INIT
    32. Fuel pump FWD No. 1 ON
    33. APU START

      Move switch to START, then release to ON

    34. APU Wait for blue indicator on APU panel
    35. APU GEN switches (L & R) ON
    36. APU bleed ON
    37. AC-voltmeter-SLCTR (R) APU GEN
    38. Parking brake SET (Light on)
    39. Ground power OFF
    40. Ground connections DSCNCT/RMVE ALL
    41. Master caution DISENGAGE
    42. COM1-Frequency METAR/DELIVERY
    43. Squawk SET
    44. Altimeter SET
    45. First ALT SET
    46. Enter into FMC and complete DEPARTURE
    47. Enter into FMC and complete ROUTE (Check discontinuities)

      See FMC tutorial: Remove Discontinuities

    48. COM1-Frequency TAXI
    49. Enter into FMC and complete TAKE OFF (P-1 & 2)

      See FMC tutorial: Takeoff and Landing Runways

    50. Elevator trim SET (FMC data)
    51. Gangway REMOVE
    52. Doors CHECK CLOSED
    53. GEN BUS TRNSFR switch CHECK COVERED
    54. Anti collision lights ON
    55. PACKs (L & R) OFF
    56. Thrust IDLE

  2. Engine S/U & Pushback

    1. Pushback START
    2. Duct pressure gauge VERIFY 30 PSI
    3. HYD pumps ALL ON
    4. Fuel pumps ALL ON
    5. Ignition selector SWITCH TO OPPOSITE
    6. L engine STRT switch GRD
    7. OIL FILTER BYPASS and LOW OIL PRESSURE indicators WAIT UNTIL EXTINGUISH
    8. L engine fuel lever IDLE
    9. L engine STRT switch When it kicks back, set to CONT
    10. R engine STRT switch GRD
    11. OIL FILTER BYPASS and LOW OIL PRESSURE indicators WAIT UNTIL EXTINGUISH
    12. R engine fuel lever IDLE
    13. R engine STRT switch When it kicks back, set to CONT
    14. ENG bleed (L & R) ON
    15. GEN engine switches (L & R) ON
    16. AC-voltmeter-SLCTR (R) GEN 1
    17. APU GEN switches (L & R) OFF
    18. APU OFF
    19. APU bleed OFF
    20. PACKs (L & R) AUTO
    21. Pitot heat switches (PROBE A & B) ON
    22. Window heat ON < 10°C
    23. Anti-ice switches ON < 10°C
    24. Yaw damper ON
    25. Flaps (5°) SET
    26. Autobrakes RTO
    27. Pushback END
    28. Flight controls CHECKED
    29. Taxi lights ON
    30. RWY turnoff lights ON
    31. TCAS TEST

  3. Taxi (Departure)

    1. Taxi to holding point
    2. AP disengage bar UP
    3. Flight directors (both) ON
    4. Auto-throttle ARM
    5. A/P IAS V2
    6. A/P Heading RWY HDG
    7. A/P Altitude Check initial ALT
    8. Autopilot SET MODES

  4. Holding Point

    1. COM1-Frequency TAKE OFF CLEARANCE
    2. Landing lights ON
    3. RWY turnoff lights OFF
    4. Position lights STROBE & STEADY
    5. TCAS TA/RA
    6. Transponder ALT ON/MODE C
    7. Line up on runway

  5. Ready for Takeoff

    1. Parking brake SET
    2. Thrust levers T.O.
    3. Parking brake RELEASE
    4. Yoke (+80 KTS) PUSH FORWARD
    5. VR ROTATE

  6. After Takeoff

    1. Trim AS REQUIRED
    2. Gear UP > 500 FPM
    3. Autopilot ON
    4. VNAV & LNAV ON
    5. Flaps RAISE ON SCHEDULE

  7. Climb

    1. Autobrakes OFF
    2. Landing lights OFF
    3. RWY turnoff lights OFF
    4. Wheel well lights OFF
    5. Window heat ON < 10°C TAT
    6. Anti-ice switches ON TAT
    7. Altimeter READJUST > TRANS ALT

  8. Cruise

    1. AP & FMC CHECK PERMANENTLY
    2. FMC PRGRS page CHECK FUEL CONSUMPTION
    3. Center fuel pump OFF (WHEN EMPTY)

  9. Descent and Approach

    1. Begin prep 30 NM before T/D
    2. COM1-Frequency METAR/Airport info
    3. Autobrakes SET
    4. ALT SET AIRPORT QNH before T/D
    5. Enter into FMC and complete ARRIVAL

      See FMC tutorial: Takeoff and Landing Runways

    6. Enter into FMC and complete ROUTE (check discontinuities)

      See FMC tutorial: Remove Discontinuities.

    7. Enter into FMC and complete INIT REF
    8. ILS FQ SET INTO NAV1 & NAV2

      See FMC tutorial: Autoland

    9. ILS CRS SET INTO BOTH CRS AND SLCTRS
    10. HGS settings: MODE PRI
    11. HGS settings: STBY Axxx ARM
    12. HGS settings: RWY SET AIRPORT ALT
    13. HGS settings: RWY SET RWY LENGTH
    14. HGS settings: GS SET GS (STD - 3)
    15. Altimeter READJUST - TRANS ALT
    16. Landing lights ON
    17. RWY turnoff lights ON
    18. Spoilers ARM

  10. Final Approach

    1. See FMC tutorial: Touchdown

    2. Flaps LOWER ON SCHEDULE
    3. Gear DOWN @ FLAPS 20
    4. Autopilot DISENGAGE
    5. Auto-throttle OFF
    6. Spoilers ENGAGE (if not auto-engaged)
    7. Thrust reverser AS REQUIRED > 80 KTS
    8. Runway VACATE

  11. Taxi (Arrival)

    1. Transponder STBY
    2. Flight directors OFF
    3. Spoilers OFF
    4. Flaps RETRACT
    5. Autobrakes OFF
    6. Taxi lights ON
    7. Landing lights OFF
    8. RWY turnoff lights OFF
    9. Position lights STEADY
    10. Wheel well lights ON
    11. Window heat OFF
    12. Anti-ice switches OFF
    13. APU START
    14. Autopilot RESET (bar up)

  12. Parking Position

    1. Taxi lights OFF
    2. Parking brake SET
    3. APU GEN switches ON
    4. APU bleed ON
    5. AC voltmeter SLCTR (R) APU
    6. L engine fuel lever CUT OFF
    7. Master caution DISENGAGE
    8. Wheel chocks SET
    9. Parking brake OFF
    10. Ground power (GPU, ASU, ACU) CONNECT & ON
    11. Doors OPEN
    12. Gangway ENABLE
    13. Seat belts OFF
    14. AC voltmeter SLCTR (R) GND PWR
    15. APU OFF
    16. APU bleed OFF
    17. Anti-collision lights OFF
    18. TCAS STBY
    19. Yaw damper OFF
    20. Pitot heat switches (PROBE) OFF
    21. ENG start switches BOTH OFF (AUTO)
    22. HYD pumps ALL OFF
    23. Fuel pumps ALL OFF
    24. Master caution DISENGAGE
    25. All external lights OFF
    26. Emergency lights OFF
    27. IRS selectors BOTH OFF

  13. Shutdown

    1. AC voltmeter SLCTR (R) STBY PWR
    2. Ground power OFF
    3. Ground power (GPU, ASU, ACU) DISCONNECT
    4. APU bleed OFF
    5. ENG bleed (L & R) OFF
    6. PACKs (L & R) OFF
    7. Isolation valve CLOSE
    8. IFE PASS seat power OFF
    9. Interior lights ALL OFF
    10. DC voltmeter SLCTR (L) STBY PWR
    11. Cabin/utility power OFF
    12. Master caution DISENGAGE
    13. Standby PWR OFF & UNCOVERED
    14. Battery OFF & UNCOVERED

Beechcraft Baron 58

  1. Preflight

    1. Landing gear lever DOWN
    2. Parking brake SET
    3. Master battery switch ON
    4. Landing lights ON
    5. Taxi lights ON
    6. Navigation lights ON
    7. Beacon ON
    8. Strobe lights ON
    9. Flaps DOWN (EXTENDED FULL)