The AudioContext was not allowed to start. (Click on the page to start it)
Your browser does not support speech recognition.
Instructions
- Click
Start
orListen
, wait for the beep before talking - Click
Next
or saychecked
to confirm the checklist item - Click
Locate
or sayhelp
to find a switch in the cockpit - Click an item in the list to go directly to it
Additional information
Alternative voice commands:
At the time of writing, only Chromium based browsers
(Chrome, Edge) support speech recognition,
and Edge's speech recognition works best.
Privacy warning: The built-in speech recognition sends your voice to a cloud service run by your browser's maker.
Privacy respected: This page does not contain external scripts nor does it try to track you.
# apt-get install speech-dispatcher espeak
# spd-conf -C
$ spd-say "Hello, world!"
$ chromium --enable-speech-dispatcher
If your browser doesn't support the Web Speech API, you can use SAM.
Settings
Included Items
Speech Synthesizer
- Read checklist items
Not all voices support pitch and speed settings
Speech Recognizer
Page Style
Joysticks
If your controller isn't listed, you may have to press a button, or unplug the controller and plug it in again.
Debug Markers
? needs clarification
! not implemented in sim
! has screenshot
ALTRNT WRDNG when spoken
Checklists
Boeing 737-800
-
Preflight
- Parking brake SET
- Battery (OHP) ON & COVERED
- Standby PWR AUTO & COVERED
- DC-voltmeter-SLCTR (L) BAT
- DC-voltmeter-SLCTR (R) STBY PWR
- Master caution DISENGAGE
- HYD pumps ALL OFF
- Fuel pumps ALL OFF
- Interior lights (Pedestal) AS REQUIRED
- Interior lights (Main panel) AS REQUIRED
- Interior lights (Overhead panel) AS REQUIRED
- Cabin/utility power ON
- IFE PASS seat power ON
- Ground power (GPU, ASI, ACU) CONNECT & ON
- Pitot covers REMOVE
- AC-voltmeter-SLCTR (R) GRND PWR
- Emergency lights ON
- Position lights: STEADY
- Lights: Wheel well, wing, logo ON
- Seat belts AUTO
- Enter into FMC FUEL/PAYLOAD
- Recirc. fans (L & R) AUTO
- Packs (L & R) AUTO
- Isolation valve AUTO
- Speed brake OFF
- IRS SEL TEST & HDG/STS
- IRS Selectors (L & R) ALIGN
- Enter into FMC and complete INIT REF
- IRS selectors (L & R) NAV
-
Enter into FMC and complete
ROUTE
See FMC tutorial: Enter the Flight Plan, Waypoints, Remove Discontinuities.
- Enter into FMC and complete PERF INIT
- Fuel pump FWD No. 1 ON
-
APU
START
Move switch to START, then release to ON
- APU Wait for blue indicator on APU panel
- APU GEN switches (L & R) ON
- APU bleed ON
- AC-voltmeter-SLCTR (R) APU GEN
- Parking brake SET (Light on)
- Ground power OFF
- Ground connections DSCNCT/RMVE ALL
- Master caution DISENGAGE
- COM1-Frequency METAR/DELIVERY
- Squawk SET
- Altimeter SET
- First ALT SET
- Enter into FMC and complete DEPARTURE
-
Enter into FMC and complete
ROUTE (Check discontinuities)
See FMC tutorial: Remove Discontinuities
- COM1-Frequency TAXI
-
Enter into FMC and complete
TAKE OFF (P-1 & 2)
See FMC tutorial: Takeoff and Landing Runways
- Elevator trim SET (FMC data)
- Gangway REMOVE
- Doors CHECK CLOSED
- GEN BUS TRNSFR switch CHECK COVERED
- Anti collision lights ON
- PACKs (L & R) OFF
- Thrust IDLE
-
Engine S/U & Pushback
- Pushback START
- Duct pressure gauge VERIFY 30 PSI
- HYD pumps ALL ON
- Fuel pumps ALL ON
- Ignition selector SWITCH TO OPPOSITE
- L engine STRT switch GRD
- OIL FILTER BYPASS and LOW OIL PRESSURE indicators WAIT UNTIL EXTINGUISH
- L engine fuel lever IDLE
- L engine STRT switch When it kicks back, set to CONT
- R engine STRT switch GRD
- OIL FILTER BYPASS and LOW OIL PRESSURE indicators WAIT UNTIL EXTINGUISH
- R engine fuel lever IDLE
- R engine STRT switch When it kicks back, set to CONT
- ENG bleed (L & R) ON
- GEN engine switches (L & R) ON
- AC-voltmeter-SLCTR (R) GEN 1
- APU GEN switches (L & R) OFF
- APU OFF
- APU bleed OFF
- PACKs (L & R) AUTO
- Pitot heat switches (PROBE A & B) ON
- Window heat ON < 10°C
- Anti-ice switches ON < 10°C
- Yaw damper ON
- Flaps (5°) SET
- Autobrakes RTO
- Pushback END
- Flight controls CHECKED
- Taxi lights ON
- RWY turnoff lights ON
- TCAS TEST
-
Taxi (Departure)
- Taxi to holding point
- AP disengage bar UP
- Flight directors (both) ON
- Auto-throttle ARM
- A/P IAS V2
- A/P Heading RWY HDG
- A/P Altitude Check initial ALT
- Autopilot SET MODES
-
Holding Point
- COM1-Frequency TAKE OFF CLEARANCE
- Landing lights ON
- RWY turnoff lights OFF
- Position lights STROBE & STEADY
- TCAS TA/RA
- Transponder ALT ON/MODE C
- Line up on runway
-
Ready for Takeoff
- Parking brake SET
- Thrust levers T.O.
- Parking brake RELEASE
- Yoke (+80 KTS) PUSH FORWARD
- VR ROTATE
-
After Takeoff
- Trim AS REQUIRED
- Gear UP > 500 FPM
- Autopilot ON
- VNAV & LNAV ON
- Flaps RAISE ON SCHEDULE
-
Climb
- Autobrakes OFF
- Landing lights OFF
- RWY turnoff lights OFF
- Wheel well lights OFF
- Window heat ON < 10°C TAT
- Anti-ice switches ON TAT
- Altimeter READJUST > TRANS ALT
-
Cruise
- AP & FMC CHECK PERMANENTLY
- FMC PRGRS page CHECK FUEL CONSUMPTION
- Center fuel pump OFF (WHEN EMPTY)
-
Descent and Approach
- Begin prep 30 NM before T/D
- COM1-Frequency METAR/Airport info
- Autobrakes SET
- ALT SET AIRPORT QNH before T/D
-
Enter into FMC and complete
ARRIVAL
See FMC tutorial: Takeoff and Landing Runways
-
Enter into FMC and complete
ROUTE (check discontinuities)
See FMC tutorial: Remove Discontinuities.
- Enter into FMC and complete INIT REF
-
ILS FQ
SET INTO NAV1 & NAV2
See FMC tutorial: Autoland
- ILS CRS SET INTO BOTH CRS AND SLCTRS
- HGS settings: MODE PRI
- HGS settings: STBY Axxx ARM
- HGS settings: RWY SET AIRPORT ALT
- HGS settings: RWY SET RWY LENGTH
- HGS settings: GS SET GS (STD - 3)
- Altimeter READJUST - TRANS ALT
- Landing lights ON
- RWY turnoff lights ON
- Spoilers ARM
-
Final Approach
-
See FMC tutorial: Touchdown
- Flaps LOWER ON SCHEDULE
- Gear DOWN @ FLAPS 20
- Autopilot DISENGAGE
- Auto-throttle OFF
- Spoilers ENGAGE (if not auto-engaged)
- Thrust reverser AS REQUIRED > 80 KTS
- Runway VACATE
-
-
Taxi (Arrival)
- Transponder STBY
- Flight directors OFF
- Spoilers OFF
- Flaps RETRACT
- Autobrakes OFF
- Taxi lights ON
- Landing lights OFF
- RWY turnoff lights OFF
- Position lights STEADY
- Wheel well lights ON
- Window heat OFF
- Anti-ice switches OFF
- APU START
- Autopilot RESET (bar up)
-
Parking Position
- Taxi lights OFF
- Parking brake SET
- APU GEN switches ON
- APU bleed ON
- AC voltmeter SLCTR (R) APU
- L engine fuel lever CUT OFF
- Master caution DISENGAGE
- Wheel chocks SET
- Parking brake OFF
- Ground power (GPU, ASU, ACU) CONNECT & ON
- Doors OPEN
- Gangway ENABLE
- Seat belts OFF
- AC voltmeter SLCTR (R) GND PWR
- APU OFF
- APU bleed OFF
- Anti-collision lights OFF
- TCAS STBY
- Yaw damper OFF
- Pitot heat switches (PROBE) OFF
- ENG start switches BOTH OFF (AUTO)
- HYD pumps ALL OFF
- Fuel pumps ALL OFF
- Master caution DISENGAGE
- All external lights OFF
- Emergency lights OFF
- IRS selectors BOTH OFF
-
Shutdown
- AC voltmeter SLCTR (R) STBY PWR
- Ground power OFF
- Ground power (GPU, ASU, ACU) DISCONNECT
- APU bleed OFF
- ENG bleed (L & R) OFF
- PACKs (L & R) OFF
- Isolation valve CLOSE
- IFE PASS seat power OFF
- Interior lights ALL OFF
- DC voltmeter SLCTR (L) STBY PWR
- Cabin/utility power OFF
- Master caution DISENGAGE
- Standby PWR OFF & UNCOVERED
- Battery OFF & UNCOVERED
Beechcraft Baron 58
-
Preflight
- Landing gear lever DOWN
- Parking brake SET
- Master battery switch ON
- Landing lights ON
- Taxi lights ON
- Navigation lights ON
- Beacon ON
- Strobe lights ON
- Flaps DOWN (EXTENDED FULL)